1. Unfold3D
1.1 Introduction
1.2 Commands
2. Unfolding step by step
3. Cutting
3.1 How to cut ?
3.2 Where to cut ?
4. Adjusting and packing
5. UNFOLD3D Interface
5.1 Menus and tools
5.2 The menu bar
5.3 The main toolbar
5.4 The viewport toolbar
5.5 The edition toolbar
5.6 Preferences
6. UV Edition
6.1 Rotation/translation/scaling
6.2 Pinning
6.3 Horizontal, vertical constraints
7. Scripting
1.1 Introduction
1.2 Commands
2. Unfolding step by step
3. Cutting
3.1 How to cut ?
3.2 Where to cut ?
4. Adjusting and packing
5. UNFOLD3D Interface
5.1 Menus and tools
5.2 The menu bar
5.3 The main toolbar
5.4 The viewport toolbar
5.5 The edition toolbar
5.6 Preferences
6. UV Edition
6.1 Rotation/translation/scaling
6.2 Pinning
6.3 Horizontal, vertical constraints
7. Scripting
1.2 Unfold3D - Commands
Here is the Unfold3D command table, with the default mouse commands.
But you can configure those commands as you wish.
To access this table, go to Edit->Mouse bindings in the menu bar.
Presets
You can use the default Unfold3D presets, or choose the presets of your main 3D modeling application, by using the dropdown "Load presets".
The following presets are available :
- Softimage XSI (new !)
- Autodesk Maya
- Autodesk 3DS Max
Your own settings